The F3 DIO 8/8 01 is a HIMatrix remote I/O device with eight digital inputs, six standard digital outputs, two two-pole digital outputs and an integrated two-port 100BASE-TX SafeEthernet switch. The 24 V DC supply, SafeEthernet addresses, I/O wiring, safety program, line-monitoring configuration and firmware revision must match the installed HIMatrix system.
Marke :
HIMAArtikelnummer :
F3 DIO 8/8 01Beschreibung :
HIMatrix digital I/O remote moduleExpand the sections to review identification and replacement checks.
Confirm the complete nameplate, manufacturer, hardware revision, electrical ratings, terminal or connector arrangement, installed rack and controller project before ordering F3 DIO 8/8 01.
Source status: HIMA manufacturer-reference documentation identifies F3 DIO 8/8 01 as a HIMatrix remote I/O device with eight digital inputs, six standard digital outputs, two two-pole digital outputs and an integrated two-port 100BASE-TX SafeEthernet switch. Verify the complete nameplate and installed HIMatrix configuration before replacement.
F3 DIO 8/8 01 is a HIMatrix remote I/O device with eight digital inputs, six standard digital outputs, two two-pole digital outputs and an integrated two-port 100BASE-TX SafeEthernet switch. It must be used with HIMatrix hardware and an engineering project that supports the installed configuration.
F3 DIO 8/8 01 belongs to the HIMA HIMatrix platform. Its eight digital inputs with configurable line monitoring, six digital outputs, two two-pole digital outputs and two 100BASE-TX Ethernet switch ports must be matched to the approved system architecture before commissioning.
For F3 DIO 8/8 01, verify eight digital inputs with configurable line monitoring, six digital outputs, two two-pole digital outputs and two 100BASE-TX Ethernet switch ports. These details determine whether the unit can perform its intended function in the installed HIMatrix system.
F3 DIO 8/8 01 should not replace a similar HIMA model by appearance or partial model text alone; the 24 V DC supply, SafeEthernet addresses, I/O wiring, safety program, line-monitoring configuration and firmware revision must match the installed HIMatrix system.
Before installing F3 DIO 8/8 01, isolate the relevant energy, record the existing wiring and slot position, and confirm that the 24 V DC supply, SafeEthernet addresses, I/O wiring, safety program, line-monitoring configuration and firmware revision must match the installed HIMatrix system.
For a F3 DIO 8/8 01 inquiry, provide quantity, clear nameplate photos, hardware revision, installed HIMatrix configuration, wiring or connector details and the required application or replacement condition.
Manufacturer-reference status for the HIMA F3 DIO 8/8 01 HIMatrix digital I/O remote module.
No current official F3 DIO 8/8 01 datasheet was located in the manufacturer's public documentation. For product documentation and compatibility details, please contact Product Specialist Frida.
CONTACT FRIDASend the complete model, quantity, and your technical or purchasing question.
Technical statements on this page are limited to exact-model manufacturer-reference documentation. No third-party product sources were used.
F3 DIO 8/8 01 is the complete reference supplied for this listing. Its function, configuration and compatible system must be matched from the complete nameplate and official manufacturer documentation before installation or replacement.
A clear workflow for sourcing, verification, shipment preparation, delivery and product assurance.
Include the complete part number, quantity and delivery destination.
IPv6 NETZWERK UNTERSTÜTZT
| Seitenverzeichnis
| XML
| Geschäftsbedingungen
| Datenschutz-Bestimmungen
MAIL US
CAIL US
Tell Us Your Needs !
